Delaware County, PA · Mold air testing

Mold Testing in Delaware County

Delaware County twins and rowhomes in Drexel Hill, Lansdowne and Yeadon, mid-century houses in Havertown and Springfield, and newer homes in Garnet Valley all handle water differently. A ValueGuard mold test compares the air in each room with the air outside so you know whether mold is growing in the house.

Every number on this page comes from 20 ValueGuard mold air tests in Delaware County, read straight off the lab reports.

Delaware County mold testing at a glance

✓From $399Two indoor rooms plus an outdoor control sample. Extra rooms $100 each.
✓Accredited independent labAir samples analyzed by EMSL Analytical (AIHA-LAP EMLAP accredited).
✓20 Delco homes testedLab results from 15 towns, Yeadon to Garnet Valley
✓Testing onlyWe don’t sell mold remediation, so we have no reason to find a problem.
✓Since 199794,000+ inspections · 4.9★ on Google

The short answer

Cost$399 for two indoor air samples plus an outdoor control; $100 per additional room. Included in our Full Protection package.
What you getA lab report with spore counts per cubic meter for every room tested, compared with the outdoor sample, plus a plain-language summary from ValueGuard.
What we find most in Delaware CountyBasements usually read highest (13 of 19 homes), but our two biggest Delco readings were in a crawlspace and an upstairs bedroom
TurnaroundLab results are usually back 1–3 business days after sampling.
Service areaAll of Delaware County: Upper Darby, Drexel Hill, Havertown, Lansdowne, Media, Springfield, Wallingford, Newtown Square and Garnet Valley

✦✦✦

Delaware County is mostly older, densely built housing: 1920s twins, post-war rowhomes and mid-century singles, with a band of newer construction to the west. More than half of the Delco homes we tested came back clean, but the ones that didn’t were not always where you’d expect. That is why we test a living area as well as the basement.

✦✦✦

i. Delaware County by the numbers

20 Delco homes, and the surprises upstairs.

Delaware County had the highest share of clean results of any county we test: 11 of 20 homes showed no sign of indoor growth. Seven had Aspergillus/Penicillium at least twice the outdoor air somewhere in the house.

20Delaware County homes air-testedLab reports since 2025
35%showed indoor mold growth7 of 20 homes had Aspergillus/Penicillium at least 2× the outdoor sample (and 500+ spores/m³) in at least one room
13 of 19basements read highestHomes where we sampled both a basement and a living area
15%had water-damage molds3 of 20 homes had Stachybotrys or Chaetomium in an indoor sample

Delaware County figures use every ValueGuard mold air test we matched to a Delco address since 2025 (20 homes, 15 towns). How we counted.

✦✦✦

ii. Real results from recent reports

What the lab actually found.

Four Delaware County tests: two problems in unexpected places, one clean house and one day when the outdoor air was the highest reading.

Moisture meter showing elevated readings on a stained basement wall in a Yeadon, Delaware County homeElevated

Yeadon · Aug 2026

The basement was fine. The bedroom wasn’t.

Aspergillus/Penicillium, spores/m³

2nd-floor bedroom31,300
Basement300
Outdoor air100

The home inspection found wet moisture staining in the basement, a leaking water heater and wet moisture damage in another part of the house. The basement air was normal, but a second-floor bedroom read 31,300 Aspergillus/Penicillium spores/m³. Testing only the basement would have missed it.

ElevatedHighest indoor reading32,900Aspergillus/Penicillium in the crawlspace

Lansdowne · Sep 2026

A crawlspace doing what crawlspaces do

Aspergillus/Penicillium, spores/m³

Crawlspace32,900
Living room550
Outdoor air200

The crawlspace was more than 160 times the outdoor sample, while the living room was only mildly elevated. A source like this can usually be dealt with before it reaches the living space.

NormalClean result0Aspergillus/Penicillium detected indoors

Havertown · Nov 2026

What a clean result looks like

Total spores, spores/m³

Bedroom1,260
Basement160
Outdoor air5,857

Both indoor rooms had far fewer total spores than the outdoor air (1,260 and 160 against 5,857) and no Aspergillus/Penicillium. A clean report is useful too: it gives the buyer a documented baseline.

ContextOutdoor control sample13,700Aspergillus/Penicillium in the outdoor sample

Sharon Hill · Jul 2025

Why we always sample outdoors

Aspergillus/Penicillium, spores/m³

Basement9,500
Front bedroom930
Outdoor air13,700

On a July day the outdoor air was higher than either room inside. Without the control sample, a basement reading of 9,500 could have looked alarming. Compared properly, it was not elevated.

Readings are spores per cubic meter of air (spores/m³) from the EMSL lab reports. Addresses are withheld. See a full sample report.

✦✦✦

iii. Why Delaware County homes are different

Twins, creeks and crawlspaces.

These are the conditions behind the high Delaware County results we see.

Older twins and rowhomesDrexel Hill, Upper Darby, Lansdowne and Yeadon are full of 1920s–1950s brick twins and rows with block or brick basements and shared walls.
Creek valleysDarby, Cobbs and Crum Creeks run through the county, and low-lying homes near them see more groundwater and basement seepage.
Crawlspaces and additionsAdditions and mid-century homes often sit over crawlspaces with dirt floors and little ventilation. Our second-highest Delco reading was in one.
Leaks upstairsWater heaters, roofs, bathrooms and windows can wet the upper floors. Our highest Delco reading was a second-floor bedroom.

✦✦✦

iv. How to read a mold report

The outdoor sample is the yardstick.

There are no EPA or other federal limits for mold spores in indoor air, so a number on its own means little. What matters is how each room compares with the air outside on the same day, and which molds are in it.

What the lab showsWhat it usually means
Indoor counts at or below outdoor, similar mix of moldsNormal. Spores are coming in from outside, which every house has.
Aspergillus/Penicillium well above the outdoor sampleThe most common sign of mold growing inside, usually tied to a damp basement, a leak or high humidity.
Stachybotrys or Chaetomium found indoorsThe lab flags these as water-damage indicators. Even low counts point to wet building materials somewhere.
One room high, others normalUsually a local moisture source. That room is where to look first.
Every indoor room highOften an HVAC or whole-house humidity problem rather than one leak.

The EPA recommends keeping indoor humidity below 60% and ideally between 30 and 50%. Fixing the moisture is what fixes the mold.

✦✦✦

v. How it works

Three steps, one visit.

1Book with your inspectionAdd mold air sampling when you schedule. We sample during the same visit, so it doesn’t add a trip.
2We pick the roomsThe basement or crawlspace plus a main living area or bedroom, and the outdoor control. If the home inspection turns up a stain or leak, we can add that room.
3Lab results, explainedEMSL analyzes the spore traps and we send the full lab report with a short summary of what it means for this house.

✦✦✦

vi. Who should test

An independent test, not a sales pitch.

Many “free mold inspections” come from companies that are paid to remove mold. ValueGuard only tests, so the result is the result.

ValueGuardRemediation company
Sells remediationNoYes
Outdoor control sampleAlwaysVaries
Accredited lab report you keepYes, EMSLVaries
Ties results to the home inspectionYes, same visit and same teamNo
CostFrom $399Free, then a remediation quote

✦✦✦

vii. Across Delaware County

From Yeadon to Garnet Valley.

Our Delaware County results include Aston, Chester Heights, Drexel Hill, Essington, Garnet Valley, Glenolden, Havertown, Holmes, Lansdowne, Media, Newtown Square, Sharon Hill, Springfield, Wallingford, and Yeadon. We test anywhere in the county, usually during the same visit as the home inspection.

Mold testing in other counties: Philadelphia · Montgomery County · Chester County · Bucks County

✦✦✦

viii. Questions we get

Mold testing in Delaware County, answered.

Should I get mold testing when buying a house in Delaware County?+
It is worth it when the home has a finished basement, a crawlspace, signs of past leaks or a musty smell. More than half of the Delco homes we tested came back clean, which is good evidence to have, and 35% showed indoor mold growth in at least one room.
How much does mold testing cost?+
Mold air sampling is $399, which covers two indoor rooms and the outdoor control sample. Each additional indoor room is $100. Mold testing is also included in our Full Protection package with the home inspection, radon, termite and sewer scope. Get exact pricing on our instant quote page or call (215) 860-3150.
Where do you test in a Delaware County home?+
Usually the basement or crawlspace and one main living area or bedroom, plus an outdoor control. Our Delco data shows why the second room matters: our highest reading was in an upstairs bedroom.
Is there a safe level of mold?+
There are no EPA or other federal limits for mold spores in indoor air. That is why every ValueGuard mold test includes an outdoor control sample: we compare each room with the air outside on the same day, and we look at which molds are present, not just the total.
How long do mold results take?+
Sampling takes well under an hour during the inspection visit. The accredited lab usually returns results 1–3 business days later, and we send you the full lab report with a short summary.
Do you remove mold?+
No. ValueGuard tests and inspects only. We don’t sell remediation, so we have no stake in the result. If a test shows a problem, we can retest after the work is done to confirm the spore levels came down.

How we counted

Delaware County figures come from the EMSL lab reports for every ValueGuard mold air test we could match to a Delaware County address, from 2025 through November 2026 (20 homes). Each home is counted once. “Indoor mold growth” means at least one indoor sample had Aspergillus/Penicillium at least twice the outdoor sample and at least 500 spores/m³. “Water-damage molds” means the lab found any Stachybotrys/Memnoniella or Chaetomium indoors. These are ValueGuard’s own results, not a random survey of every home in the county; homes are often tested because a buyer or owner already had a concern.

Buying in Delaware County?

Know what’s in the air before you sign.

Mold air sampling from $399 · added to any ValueGuard home inspection

Schedule Mold TestingGet an Instant Quote

or call (215) 860-3150