Radon testing · Philadelphia, PA

Radon Testing in Philadelphia, PA

We have tested more than 11,000 Philadelphia homes for radon since 2012. Most rowhomes come back low, but about 1 in 11 does not, and our single highest reading anywhere came from a South Philly rowhouse. Here is what our neighborhood-by-neighborhood data shows.

$190 · 2-day test (48-hour minimum) · PA DEP-certified radon tester

Odds of a 4.0+ result in Philadelphia
1 in 11
homes we tested (9.1% of 11,497)
U.S. average (EPA estimate)1 in 15
From our case files

The highest radon reading we’ve ever recorded came from a South Philly rowhome

South Philadelphia is one of the lowest-radon parts of the city on average. It is also where we measured 404.2 pCi/L, the highest result in more than 22,000 radon tests across our whole service area. Averages describe neighborhoods. Tests describe houses.

404.2 pCi/L
101× the EPA action level
ZIP 19148, South Philadelphia
Attached rowhome · July 2015
237.9 pCi/L
59× the EPA action level
ZIP 19118, Chestnut Hill
Detached home · June 2017
155.0 pCi/L
39× the EPA action level
ZIP 19146, Graduate Hospital / Point Breeze
Attached rowhome · June 2020
The data

What 11,497 Philadelphia radon tests tell us

Philadelphia has the lowest radon rate of any county we serve, with a median result of 1.4 pCi/L. That is good news, but it is not a pass. 9.1% of the city homes we tested came in at or above the EPA action level of 4.0 pCi/L, and another 24.2% landed between 2.0 and 3.9. In total, a third of city homes tested above 2.0, the level where EPA says to consider fixing.

How Philadelphia results break down

Share of 11,497 homes in each result range

Under 2.0 pCi/L: 66.7%
2.0–3.9 pCi/L: 24.2%
4.0–9.9 pCi/L: 7.9%
10–19.9 pCi/L: 0.8%
20+ pCi/L: 0.3%

Share of homes at 4.0+ pCi/L, by county

ValueGuard tests, 2012–2026, vs. EPA national estimate

Chester County
28.4%
Bucks County
26.3%
Montgomery County
26.1%
Delaware County
20.6%
Philadelphia
9.1%
U.S. (EPA estimate)
6.7%
Look up your area

Philadelphia radon results by neighborhood

Radon risk in the city follows the neighborhoods with more detached and twin homes. The northwest (Chestnut Hill, Roxborough, Manayunk, Mount Airy) and the Far Northeast (Bustleton, Somerton, Fox Chase) run well above the city average, along with Overbrook and Frankford. Dense rowhome neighborhoods in South Philadelphia, Center City and lower North Philadelphia run lowest.

At or below U.S. average1–2× U.S. average2–4× U.S. averageMore than 4× U.S. average
Philadelphia average (9.1%)U.S. average, EPA estimate (6.7%) · Bar length runs from 0 to 30%. Colors compare each area with the U.S. average.
ZIPNeighborhoodHomes testedMedianShare of homes at 4.0+ pCi/L
19118Chestnut Hill1492.4
25.5%1 in 3.9
19124Frankford / Juniata1221.4
23.8%1 in 4.2
19115Bustleton642.9
21.9%1 in 5
19151Overbrook / Wynnefield Heights1181.8
20.3%1 in 5
19116Somerton (small sample)461.8
17.4%1 in 6
19133Fairhill (small sample)461.9
17.4%1 in 6
19128Roxborough / Manayunk7381.8
16.8%1 in 6
19119Mount Airy5171.8
16.4%1 in 6
19127Manayunk / East Falls1541.8
15.6%1 in 6
19104University City / Powelton1261.6
14.3%1 in 7
19137Bridesburg (small sample)321.4
12.5%1 in 8
19129East Falls / Allegheny West1981.4
11.6%1 in 9
19121North Philadelphia / Brewerytown3261.6
11.3%1 in 9
19111Fox Chase / Burholme1501.6
11.3%1 in 9
19140Hunting Park / Nicetown (small sample)461.3
10.9%1 in 9
19122Kensington South / Olde Kensington2481.5
10.1%1 in 10
19125Fishtown / Port Richmond8841.5
10.1%1 in 10
19130Fairmount / Spring Garden6261.5
9.9%1 in 10
19144Germantown3401.6
9.7%1 in 10
19123Northern Liberties / Fairmount East2731.6
9.2%1 in 11
19132Strawberry Mansion / Allegheny (small sample)461.4
8.7%1 in 11
19131Wynnefield / Belmont1311.2
8.4%1 in 12
19149Mayfair / Oxford Circle (small sample)480.9
8.3%1 in 12
19139West Phila / Walnut Hill / Cobbs Creek1711.2
8.2%1 in 12
19114Torresdale (small sample)491.3
8.2%1 in 12
19146Graduate Hospital / Point Breeze1,2761.4
7.6%1 in 13
19106Old City / Society Hill1571.4
7.6%1 in 13
19143Southwest Phila / Cedar Park / Kingsessing5111.3
6.1%1 in 16
19150Cedarbrook / West Oak Lane1001.1
6.0%1 in 17
19147Queen Village / Bella Vista / Pennsport1,1371.5
5.7%1 in 18
19135Tacony / Wissinoming711.1
5.6%1 in 18
19134Port Richmond / Harrowgate3121.4
5.4%1 in 19
19120Olney / Feltonville1000.9
5.0%1 in 20
19138East Germantown / West Oak Lane1060.9
4.7%1 in 21
19126Oak Lane (small sample)491.1
4.1%1 in 24
19107Washington Square West / Chinatown771.4
3.9%1 in 26
19103Rittenhouse / Logan Square1531.1
3.9%1 in 26
19136Holmesburg871.3
3.4%1 in 29
19148South Philly East / Whitman / Packer Park7771.3
3.2%1 in 31
19145South Philly West / Girard Estate / Grays Ferry6071.1
3.0%1 in 33
19152Rhawnhurst (small sample)341.4
2.9%1 in 34
19154Parkwood / Morrell Park741.1
2.7%1 in 37
19142Paschall / Elmwood540.8
1.9%1 in 53
19141Logan / Fern Rock641.1
1.6%1 in 62

No match in our table. Areas with fewer than 25 tested homes aren’t listed. Call 215-860-3150 and we’ll tell you what we’ve seen nearby.

ZIP codes with at least 25 tested homes. Neighborhood names are approximate; most ZIP codes cover several neighborhoods.

Myth vs. data

Four things Philadelphia buyers assume about radon

Myth
“Rowhomes don’t really get radon.”
What our data shows

Rowhomes test lower on average, but 7.5% of the Philadelphia rowhomes we tested were still 4.0+, about 1 in 13. Our three highest city readings include two rowhomes.

Detached
19.4%
Attached
7.5%
Myth
“My neighbor tested low, so we’re fine.”
What our data shows

On 42.1% of the 990 city streets where we’ve tested three or more homes, at least one came in under 2.0 pCi/L and another came in at 4.0 or higher. Next door is not a forecast.

Myth
“A finished basement keeps radon out.”
What our data shows

It helps a little. 7.9% of city homes tested in a finished basement were 4.0+, versus 10.7% in unfinished basements. Drywall and carpet don’t seal a foundation.

Unfinished
10.7%
Finished
7.9%
Myth
“Only a winter test counts.”
What our data shows

In the city, results were steady year-round. Fall actually ran highest and winter lowest in our data, so test whenever you’re buying.

Winter
7.2%
Spring
9.2%
Summer
9.4%
Fall
10.4%

How a ValueGuard radon test works in Philadelphia

Pennsylvania requires anyone hired to test for radon to be certified by the PA Department of Environmental Protection, and real estate tests follow a specific state protocol. Most of our Philadelphia radon tests are scheduled alongside the home inspection, so there is one appointment and the result is in hand well inside a typical inspection contingency. A ValueGuard radon test is $190 and runs 2 days, with a 48-hour minimum test period.

1
Closed-house conditions start 12 hours early

Windows and exterior doors stay closed (except for normal entry and exit) starting 12 hours before the test and for the whole test. We send the seller or occupant clear instructions in advance.

2
We place the monitor in the lowest livable level

In most Philadelphia homes that means the basement, finished or unfinished. The device sits away from drafts, sump pits, and exterior walls, per PA DEP protocol.

3
The test runs a minimum of 48 hours

Short-term real estate tests run at least 48 hours. Anti-tampering measures are used and a non-interference agreement is signed, both required for Pennsylvania real estate radon tests.

4
You get a clear result and what it means

Your report shows the average radon level for the test period and where it falls against the EPA action level, so you and your agent can decide quickly what, if anything, to negotiate.

What your radon result means

Radon is measured in picocuries per liter of air (pCi/L). EPA estimates radon causes about 21,000 lung cancer deaths a year in the U.S. and is the leading cause of lung cancer among non-smokers.

Below 2.0 pCi/L

Low. No action needed, though EPA notes there is no known completely safe level. Retest after major renovations or if you finish the basement.

2.0 – 3.9 pCi/L

Below the action level, but EPA suggests homeowners consider reducing radon in this range. Many buyers use this result to plan a future system or a long-term retest.

4.0 pCi/L or higher

At or above the EPA action level. EPA recommends fixing the home. In a sale, this is usually resolved with a seller-installed mitigation system (with a post-mitigation retest) or a credit.

Why Philadelphia buyers and agents choose ValueGuard

Since 1997

Family-owned ASHI inspection company with 94,000+ inspections completed across Southeastern PA.

Designated radon team

A dedicated team handles radon, mold, lead and sewer testing, so your test is placed and retrieved on schedule.

Our own local data

We have tested more than 22,000 homes for radon since 2012, which is where every number on this page comes from.

Rated 4.9 stars

1,400+ Google reviews and BBB accredited. Pair radon with your home inspection in one visit.

Philadelphia radon testing FAQs

How much does radon testing cost in Philadelphia?

A ValueGuard radon test in Philadelphia is $190. The test runs 2 days (a 48-hour minimum under PA DEP protocol) and is performed by a PA DEP-certified radon tester. Most clients add it to their home inspection so the monitor is placed during the same visit.

Do Philadelphia rowhomes really need a radon test?

Yes. Rowhomes test lower on average (7.5% of the Philadelphia rowhomes we tested were 4.0 pCi/L or higher), but our highest reading anywhere, 404.2 pCi/L, came from a South Philadelphia rowhome. Results from neighboring homes cannot predict yours.

Which Philadelphia neighborhoods have the highest radon levels?

In our data, Chestnut Hill (19118) had the highest share of homes at 4.0 pCi/L or above at 25.5%, followed by Frankford/Juniata (19124), Bustleton (19115) and Overbrook (19151). Roxborough, Manayunk and Mount Airy were also above the city average.

How long does a radon test take in Philadelphia?

A real estate radon test runs a minimum of 48 hours under closed-house conditions, which start 12 hours before the test. We usually set it up during your home inspection.

Can I use a hardware-store radon kit for my home purchase?

For a Pennsylvania real estate transaction, the test should be done by a PA DEP-certified tester following the state real estate protocol, including anti-tampering measures and a signed non-interference agreement. DIY kits are useful for homeowners but are not built for a sale.

What happens if the radon test comes back at 4.0 pCi/L or higher?

EPA recommends fixing the home. In a sale, buyers usually ask the seller to install a radon mitigation system by a PA DEP-certified mitigator, followed by a retest, or negotiate a credit. Your agent will advise on the best route for your contract.

Does ValueGuard test for radon outside the city?

Yes. We test throughout Bucks, Chester, Delaware and Montgomery Counties, where radon rates run roughly two to three times higher than in Philadelphia.

Book your Philadelphia radon test

Add radon to your home inspection or schedule it on its own. Our office is open Monday to Friday 8:30–5:00 and Saturday 9:00–4:00.

About this data: figures come from 11,497 radon tests ValueGuard performed in Philadelphia from December 2012 through November 2026. Each home is counted once (its first test), and homes that already had a radon mitigation system are excluded. The U.S. comparison is EPA’s estimate that nearly 1 in 15 homes has radon at or above 4.0 pCi/L. Results from other homes cannot predict the radon level in yours. The only way to know is to test.